What is the wiper insert? The wiper insert is designed with a wiper edge that is situated where the straight edge meets the corner radius. The dimension is like the image as follows: The advantages of the wiper insert than common insert wit...

Chipbreaker PCD Inserts f or machining Aluminum alloy When machining aluminum alloy engine, it will exist chips in the Cavity in the process which will affect the engine product and will cause serious problems. The main reasons are as follo...

Part 1 The chips problems in the process of machining Alumium alloy Chips always is a difficult problem in the high speed cutting, boring process. It has small allowance, high linear speed, the cutting heat will increase intensely with the...

For machining the Wind Turbine Blades, Halnn has so many different grades for drilling and milling composites, the following is some application: 1.Milling the endsurface of the wind turbine blades (1)Insert Type: PCD Milling Insert with fu...

As we all know,Tungsten Carbide Rings belong to a type Hard alloy roll,it has good abrasive resistance and high impact resistance. It has been widely used in the production of rods, wire rods, rebars, and seamless steel tubes, etc. And it u...